post

When you are thinking of doing metal roof installing then the first thing you should keep in mind the materials you need to do the job. These materials will include decking, hardware, flashing which will be appropriate for the existing roof’s pitch, frame and metal roof panels. The best option is to call for the metal roofing installer Oshkosh.

If you can draw the detail of the roof before then it will be very easy for you to purchase the materials. Check what hardware you need for the roofing panels. If you think of doing the metal roofing installation over the existing one then you will need to install furring strips or asphalt paper in between the two roofs. You should collect all the correct tools which you will need for your work.  Try to do this work in advance so that your job will be over quickly and correctly. It is very important to read the manufacturer’s instructions properly before you start the job.

It is better to call metal roofing installer  they will make sure that there is good drainage system from the roof. They will check the pitch of your existing roof decking. The reason behind it is that there are different styles of metal roofing panels and each one will have different roof pitch requirement. Once you select the pitch of your roof then you must select from the different designs and styles for a particular pitch. If the pitch of your roof is low then you have to add another sealant and hardware so that the roof is watertight. Many professional mechanics here in Oshkosh use internal or external fasteners for their metal roofing installation but the external fasteners are easy to install and use. The type of trims, fasteners and flashing will depend on the roofing panels you select for your house.

Products you will need for metal roofing installation are:-

  1. Fastening tools
  2. Eye protection
  3. Gloves which have a good grip
  4. If it is for smaller roofing work you will need cordless drill that will have a fastener attachment. But if you are doing for large roofing then you will need a good driver.
  5. For cutting the panel ribs you will need a nibbler attachment or power saw that will be with the carbide blade for metal cutting. This all will depend on the size of the job.
  6. For cutting the obstructions you will also need small hand held metal snips. This will be either left hand or right hand cuts.

When you are installing the metal roofing the panels should be from the peak or the gable downward. It should be in the opposite direction of the winds that carry the rain. To do the work faster you can pre-drill the sub-roof. Though there are videos on the internet how to install it but it is always better to call for professional mechanics. Mechanics in Oshkosh know their job very well and they are doing this for years.